|
|
Post by independentenergy on Feb 6, 2013 9:14:34 GMT -8
hi guys i am Andrea,i am Italian.
No speak English sorry.
sorry if it is not clear how I write.
this is a picture of my stove.
I also have some file skp
I would like to ask for advice, I can post the file?
thanks
|
|
|
|
Post by satamax on Feb 6, 2013 9:20:03 GMT -8
Ciao Indie, mi piace.
|
|
|
|
Post by independentenergy on Feb 6, 2013 10:17:16 GMT -8
ciao Max grazie ma non so se può funzionare... si capisce il mio Inglese?  |
|
|
|
Post by satamax on Feb 6, 2013 10:43:14 GMT -8
Piu o meno, va bene.
|
|
|
|
Post by independentenergy on Feb 6, 2013 11:08:55 GMT -8
phases of construction
|
|
|
|
Post by independentenergy on Feb 6, 2013 11:13:16 GMT -8
white insulating bricks
|
|
|
|
Post by independentenergy on Feb 6, 2013 11:17:03 GMT -8
the upper part and division of the gas
|
|
|
|
Post by independentenergy on Feb 6, 2013 11:21:54 GMT -8
rear box
|
|
|
|
Post by independentenergy on Feb 6, 2013 11:24:02 GMT -8
the oven
|
|
|
|
Post by Vortex on Feb 6, 2013 14:47:06 GMT -8
I like it, but without the oven, just with the cookstove top.
|
|
|
|
Post by independentenergy on Feb 7, 2013 7:03:47 GMT -8
the oven is very important to me, I often bread at home.
removing the rings by the plate the flame directly heats the oven, the gas exit from the chimney dedicated.
I would like to use two flow controllers one for each chimney
this is a project you think would work well?
I would like some opinions
I'm going to put two fans with aluminum tubes to heat the air.
thanks
|
|
|
|
Post by independentenergy on Feb 11, 2013 2:47:51 GMT -8
new design:
the first chamber is 260 liters
the second 150 liters.
hearth placed side
|
|
|
|
Post by Vortex on Feb 11, 2013 10:47:39 GMT -8
Yeah, nice, that would work. I think I'd divide the first bell into 2 though for a bit of extra mass.
|
|
|
|
Post by independentenergy on Feb 11, 2013 13:02:18 GMT -8
I thought too! but I'm afraid to be too small and accelerates the flow when it is still hot, I think ...
I have an idea in mind, use a bypass to ignite the chimney for 5/10 minutes at the start, only to be closed when the burner is up to speed
|
|
|
|
Post by independentenergy on Feb 15, 2013 0:53:50 GMT -8
I tried another drawing, the first bell divided into two, as recommended by vortex.
I have a question about the channel that transfers gas from the first bell to the second, they are both low ... the gas will be able to go up and heat the second bell, or go directly to the third section?
thanks
|
|
