|
|
Post by Orange on Aug 14, 2019 1:00:58 GMT -8
for the record - here's the thing powered by 160mm J-tube. It will be replaced by DSR2. it heats a small space, only 16m2, and the bricks heat up well in 2h but the air temperature stays low so the j-tube doesn't have enough power to even when I use a metal barrel.
|
|
|
|
Post by Orange on Aug 17, 2019 12:02:13 GMT -8
I won't make this mistake again, 10cm of insulation under firebox is not enough even for a small heater, it burned down the wood: new look: |
|
|
|
Post by Orange on Sept 13, 2019 8:29:33 GMT -8
|
|
|
|
Post by satamax on Sept 14, 2019 23:26:43 GMT -8
Orange, careful, i don't think you have enough gap above the secondary chamber.  |
|
|
|
Post by Orange on Sept 15, 2019 9:27:42 GMT -8
You think it could be a problem? Idea is to have top gap 10-15cm, too keep the whole structure low as possible. I had similar top gap on j-tube, CSA-wise it shouldn't be a restriction.
I know Peter recommends 30+cm for heat extraction, but that's not a priority here.
|
|
|
|
Post by satamax on Sept 15, 2019 11:50:02 GMT -8
what is your rectangle projection into the gap?
|
|
|
|
Post by Orange on Sept 15, 2019 13:48:41 GMT -8
Exit Port Dimensions (mm)
Width 246
Height 71
Depth 49
|
|
|
|
Post by martyn on Sept 15, 2019 22:51:02 GMT -8
What is your plan for cooking, do you intend to use the top box and the outside top as a hot plate?.
I have read most of the post about the stoves development but I can’t get my head around using the top box as an oven.
When the stove is running surly it will be to hot to cook anything inside the box?
|
|
|
|
Post by Orange on Sept 16, 2019 3:14:46 GMT -8
cooking will be done inside the firebox like in an oven (will add a sliding door) and on top of the bell. top box will be made out of CFB and will have a fixed window just for the view  |
|
|
|
Post by martyn on Sept 16, 2019 3:39:41 GMT -8
Ok that is great but do you have any ideas of what the temperature will be inside the top box and do you have a plan to regulate the temperature?
I can only guess but it seems to me that the top box may be over 500c?
|
|
|
|
Post by alarin on Sept 16, 2019 8:14:47 GMT -8
It reaches 600 С degrees in my bell.
|
|
|
|
Post by Orange on Sept 17, 2019 11:14:50 GMT -8
on top of the bell it might get 400C. You can regulate cooking temp by moving the pot on the colder side or reducing fire |
|
graham
Junior Member
Posts: 74
|
Post by graham on Sept 18, 2019 18:01:32 GMT -8
Is the oven the same as the top box which is being made of CFB?
|
|
|
|
Post by Orange on Sept 19, 2019 0:37:51 GMT -8
oven = firebox, taller than top box and made out of firebricks.
|
|
|
|
Post by Orange on Sept 24, 2019 10:51:48 GMT -8
|
|
