joseph
Junior Member
Posts: 66 
|
Post by joseph on Nov 22, 2013 9:07:20 GMT -8
It is difficult for me to find conclusions to some of the projects. I was expecting to see some kind of summary, diagram, photograph, or other explanation of the final result. Instead, the threads seem to show a project that is ongoing, and then the thread is locked.
What is the final result of the "Small-scale development" stove? Is it the Dragon Core? Do I look at the Dragon website for the conclusion?
What is the final configuration of the "Adventures with a horizontal feed" stove? For example, what is the configuration of the P-channel, for example - is it a slot or a duct?
|
|
|
|
Post by pinhead on Nov 22, 2013 9:52:45 GMT -8
|
|
|
|
Post by grizbach on Nov 22, 2013 10:03:56 GMT -8
With my project it is ongoing. It's basically done, but I may make some changes here and there to see if it improves.
I don't have any projects where I stop and proclaim "It is finished!"
|
|
joseph
Junior Member
Posts: 66
|
Post by joseph on Nov 22, 2013 12:11:04 GMT -8
The "Peterberg Batch Box Dimensions" thread has the spreadsheet numbers in the screen snapshot "Peterberg Capture.JPG". Looking at those numbers, it is not obvious what they refer to, since there is no diagram. For example, where does the P-channel go? How close to the riser is it? What are the dimensions of the sloping sides of the burn chamber?
|
|
|
|
Post by pinhead on Nov 25, 2013 7:38:05 GMT -8
The "Peterberg Batch Box Dimensions" thread has the spreadsheet numbers in the screen snapshot "Peterberg Capture.JPG". Looking at those numbers, it is not obvious what they refer to, since there is no diagram. For example, where does the P-channel go? How close to the riser is it? What are the dimensions of the sloping sides of the burn chamber? If you want a better explanation of the Batch Box than anything I can write out, download Google Sketchup and open the attached .skp file. Here's a couple of screenshots of that 3-D file.   Attachments:BatchBox.skp (265.16 KB)
|
|
docbb
Junior Member
Back from ZA
Posts: 92
|
Post by docbb on Nov 25, 2013 10:15:01 GMT -8
|
|
