|
C/O
Sept 20, 2014 9:36:40 GMT -8
Post by azdave on Sept 20, 2014 9:36:40 GMT -8
Which clean out cover work the best easier to seal the innies (cork style) or the outties (cap style) ?
Azdave
|
|
|
C/O
Sept 20, 2014 19:34:01 GMT -8
Post by azdave on Sept 20, 2014 19:34:01 GMT -8
This is for a 8" system and the innies are the crimped ones that go into the fittings the outies are the smooth ones that go over the fittings.
Azdave
|
|
|
C/O
Sept 20, 2014 22:26:31 GMT -8
Post by satamax on Sept 20, 2014 22:26:31 GMT -8
You can also get inner ones which are smooth
|
|
|
C/O
Sept 21, 2014 1:46:19 GMT -8
Post by Dan (Upstate NY, USA) on Sept 21, 2014 1:46:19 GMT -8
Cap style is much easier, and seals better too. I have both in my heat bench...
|
|
|
C/O
Sept 21, 2014 9:09:46 GMT -8
Post by azdave on Sept 21, 2014 9:09:46 GMT -8
Thanks
|
|
|
C/O
Sept 22, 2014 1:06:33 GMT -8
Post by Dan (Upstate NY, USA) on Sept 22, 2014 1:06:33 GMT -8
I used "T"s in my bench were the cleanouts went. Some angles and loops required caps or plugs depending on were I decided to put the cleanout and at what angle. I think there are two places for plugs and one in-line for caps...
|
|